Флудильня

This reference will guide you through the process of setting up your Xbox 360 development kit. First, follow these steps to connect your console:

1. Connect the AV pack that matches the input of your TV or monitor to the AV output on the back of the console.

2. Connect the video cable to the video input of your TV.

3. Connect the Xbox 360 controller to the console through the front USB port of the console.

4. Use a standard Ethernet cable (not provided) and connect one end to the Ethernet port on the back of the console. Connect the other end to your network.

5. Connect your PC to the USB emulation port: 1. Connect the USB cable (provided) to the USB port on console labeled "DVD EMU". 2. Connect the other end of the USB cable to the development PC.

6. Connect power to the console: The Xbox 360 development console ships with both 100v-110v and 220v power supply units (PSU). If you use a converter with the PSU, you must use a CE-Marked 110v-220v 750VA step-down converter

1. Connect the power supply to the console. 2. Connect the power cord to the power supply. 3. Connect the power cord to the power outlet.

Once fully connected, the console is ready for power. Turn on your display, then press the power button to the left of the USB ports on the front panel of the console. This will launch the console's boot sequence, during which time the TV will display an invalid video signal. When the console has finished the boot sequence, a valid video signal will be sent to the TV and the Xbox 360 Launcher will be displayed.

Note: If the console has completed its boot sequence, but a valid video signal still isn't being received, it may be necessary to reset the video mode. You may use one of the following shortcut button combinations on the controller to quickly set video mode:

o For NTSC-M, left trigger+right trigger+D-pad right* o For NTSC-J, left trigger+right trigger+D-pad left o For PAL-50, left trigger+right trigger+D-pad up** o For VGA, left trigger+right trigger+D-pad down

* PAL-I 60 Hz (Europe) ** Not supported in the current release

Note: The flicker filter is not enabled. As a result, images will flicker on NTSC displays. The flicker will not show up when outputting to HDTV or VGA. The flicker filter will be enabled in a future release.

The first time the console boots, the Xbox 360 Launcher will request that you enter a name for your console. Using the controller, enter a name and then select OK to continue. The Xbox 360 Launcher will display a list of the available applications on the console.

To turn off power to the console, simply press the power button.

Important information about the console hardware

* Make sure that you use only the power supply that comes with the development console.

* Always plug the power supply into the development console before plugging the power supply into the outlet.

* Console hardware is sensitive to static electricity; therefore it is recommended that any static electricity be dissipated before plugging in a controller. For example, walking across a carpet and plugging in a controller without first touching a grounding surface may reset the console.

Unpublished work. Copyright 2000-2006 Microsoft Corporation. All rights reserved.